Forums

Clape.ro :: Forums :: Echipamente si accesorii :: Echipamente audio
 
<< Previous thread | Next thread >>
Mixer yamaha emx5000-12
Go to page       >>  
Moderators: admin, pustiulica, angelitto
Author Post
Kapytanu
Wed, 02 Apr 2014, 12:43AM
Guest
Va salut! Am si eu o intrebare pentru cei care cunosc acest model. Functioneaza la 2 ohmi?

Back to top
sarac.lipit
Wed, 02 Apr 2014, 02:20PM

Registered Member #45
Joined: 29 May 2008
Posts: 2431
 teoretic orice amplificator funcţionează de la 2 OHM, doar că ''la blană'' se încinge... da' faci mititei, o ceafă...ceva iar iarna îl ţii la picioare.
Pui şi tu cabluri mai lungi şi-i mai măreşti impedanţa.
Adevărul este că sună mai prezent cu cît e mai mică impedanţa şi mai fleşcăit spre 16 OHM

[ Edited Wed, 02 Apr 2014, 02:20PM ]
Back to top
Kapytanu
Wed, 02 Apr 2014, 11:36PM
Guest
Ms. Ma interesa daca as putea sa conectez 3 boxe de 8 ohmi pe un canal. Stii ceva sarac lipit?
Back to top
vermona
Thu, 03 Apr 2014, 11:21AM

Registered Member #307
Joined: 10 Jul 2008
Posts: 54
 nu poti pe modelul emx yamaha

Back to top
sarac.lipit
Thu, 03 Apr 2014, 03:54PM

Registered Member #45
Joined: 29 May 2008
Posts: 2431
 probează şi tu
pune 2 înseriate şi una în paralel, dacă-i moale soundu'... pune-le toate-n paralel.
Dacă amplifu' are protecţiile OK n-ar trebui să se întîmple nimic... decît să se întrerupă dacă-i prea încins şi-n 2 minute-şi revine

Back to top
Kapytanu
Fri, 04 Apr 2014, 03:45AM
Guest
am pus. sound-ul nu e moale. nu se schiba cu nimic diferenta la sunet dacapun o boxa pe canal , doua sau trei. se aude volumul la fel nu scade la niciuna. mi-e frica sa nu pateasca ceva nu stiu.

Back to top
Kapytanu
Fri, 04 Apr 2014, 03:48AM
Guest
vermona zici ca nu functioneaza in2 ohmi?
Back to top
ValiS
Fri, 04 Apr 2014, 06:51AM
Guest
Daca in specificatiile mixerului nu spune ca poate fi folosit si in 2 ohmi iti recomand sa nu pui 3 boxe pe canal...Poti arde etajul final,se incinge ca la balamuc..Eu nu as avea incredere.Si eu am un powermate 1000-1 Dynacord,dar n-am curaj sa pun 6 boxe.E alegerea ta..Teoretic ar merge,spune SaracLipit..! Da...dar cred ca doar teoretic...!

Back to top
adriankorgpa
Fri, 04 Apr 2014, 09:09AM
Guest
POate ca te ajuta :

General specifications

Maximum output power
SPEAKERS: 500 W+500 W/4W @0.5% THD at 1 kHz
325 W+325 W/8W @0.5% THD at 1 kHz
BRIDGE: 1000 W/8W @0.5% THD at 1 kHz
Frequency response
20 Hz–20 kHz +1 dB, –3 dB @1 W output into 8W (SPEAKERS OUT)
20 Hz–20 kHz +1 dB, –3 dB @+4 dB output into 600W
(ST OUT, ST SUB OUT, MONO OUT, AUX SEND, EFFECT SEND)
Total harmonic distortion
Less than 0.5% @20 Hz–20 kHz, 250 W output into 4W (SPEAKERS OUT)
Less than 0.3% @20 Hz–20 kHz, +14 dB output into 600W
(ST OUT, ST SUB OUT, MONO OUT, AUX SEND, EFFECT SEND)
Hum & noise
(Average, Rs=150W)
(with 20 Hz–20 kHz BPF)
–128 dB equivalent input noise, –65 dB residual output noise (SPEAKERS OUT)
–95 dB residual output noise (ST OUT, ST SUB OUT, AUX SEND)
–84 dB (ST OUT, MONO OUT)
ST master/MONO master fader at nominal level and all channel
On switches off and all channel fader at minimum.
–64 dB (68 dB S/N)
(ST OUT, MONO OUT)
ST master fader at nominal level and one channel On switch
on and one channel fader at nominal level and one channel
Gain control at nominal level.
–81 dB (AUX SEND)
Master fader at nominal level and all channel On switches off
and all channel level control at minimum.
–80 dB (EFFECT SEND) All channel level control at minimum.
Maximum voltage gain
108 dB INPUT A/B to SPEAKERS OUT
84 dB INPUT A/B to ST OUT, MONO OUT
80 dB INPUT A/B to AUX SEND (PRE)
90 dB INPUT A/B to AUX SEND (POST)
78 dB INPUT A/B to EFFECT SEND
58 dB ST CH IN to ST OUT
Crosstalk at 1 kHz 68 dB adjacent input, 68 dB input to output
Input channel equalization
±15 dB Maximum
HIGH 10 kHz shelving*
MID 250 Hz–5 kHz peaking
LOW 100 Hz shelving*
* Turn over/roll off frequency of shelving: 3 dB below maximum variable level.
ST Input channel equalization
±15 dB Maximum
HIGH 10 kHz shelving*
MID 2.5 kHz peaking
LOW 100 Hz shelving*
* Turn over/roll off frequency of shelving: 3 dB below maximum variable level.
CH peak indicators Red LED on each channel lits when POST EQ signal reaches the level –3 dB below clipping.
CH signal indicators Green LED on each channel lits when POST EQ signal reaches the level –10 dB.
Meters 13 points LED meter
Power amp select switch 500W + 500W, 300W + 300W, 100W + 100W
Limiter Comp. : THD³0.5% (SPEAKERS OUT)
LIMIT indicators Turn on : THD³0.5% (SPEAKERS OUT)
Graphic equalizer 9 bands (63, 125, 250, 500, 1k, 2k, 4k, 8k, 16k Hz), ±12 dB Maximum
Internal digital effect 1 16 programs, parameter control
Internal digital effect 2 16 programs, parameter control, tap delay control, foot switch (DIGITAL EFFECT ON/OFF, TAP)
Foot switch (FC5) Digital effect 2 mute: on/off, Tap delay
Protection circuit (Power amp) POWER switch on/off mute, DC detection, TEMP (heatsink temp. ³90°C)
Fan circuit stop — low speed (50°C) — variable — high speed (70°C)
Phantom power +48 V (balanced input)
Option FC5 (Foot switch), RK-124 (EMX5000-12)
Power requirement/
Power consumption
USA and Canada:120 V AC 60 Hz, 400 W
Europe: 230 V AC 50 Hz, 550 W
Other: 240 V AC 50 Hz, 550 W

Back to top
vermona
Fri, 04 Apr 2014, 10:29AM

Registered Member #307
Joined: 10 Jul 2008
Posts: 54
 yamaha emx nu are nicio serie care poti pune 3 boxe pe un canal.....lucru clar.......singurul model este dynacord pm 1002....si 1003...dar si alea nu se stie cat functioneaza de bine si mult .....indicat pentru 3 boxe pe canal sunt amplificatoare separate care sunt concepute pentru a fi folosite in regim de forjare...cluburi..concerte...orcum la nunti linistite cu 4 boxe sateliti si doi basi care ar fi bine sa fie activi nu o sa ai treaba...deci nu uita emx nu functioneaza cu 3 boxe pe canal...

Back to top
Go to page       >>   

Jump:     Back to top
Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by Clape.ro


Comentarii noi


[download] Sistem de operare (OS) și resurse Korg PA3 Latest comment Posted by admin on 19 Sep 2025, 11:07
@ion_muzicantu: Scrie și ce versiune este!


[Content] Re: Download access request Latest comment Posted by andrzejre on 17 Sep 2025, 13:21
Hello, I would like to request download access again. I have uploaded 20 files, some of which have been well rated.admin:You have received access to 2 downloads per day, for a peri [more ...]


[download] SET Yamaha PSR 607s Latest comment Posted by CrysMM on 16 Sep 2025, 22:05
Sunt doar style de la clapele vechi fara sampler, nu este un set pentru S670. Faptul ca sunt compatibile cu S670, este altceva.


[download] SET AgyBani - Korg PA1000, Part.1 Latest comment Posted by Gimialex on 14 Sep 2025, 20:02
Are cateva style-uri frumoase, niste sound-uri placute.Facand conversia pentru Pa600 (ca asta detin), cand am incercat sa incarc, unele fisiere sunt protejate, fiind nevoie de USB. [more ...]


[download] Korg Pa5x Disco Full Set .KST Latest comment Posted by Jovba13 on 13 Sep 2025, 07:34
Solicitarea permisiunilor pentru a descărca acest set korg pa5x🙏🙏🙏

Evangelos Odysseus Papathanassiou - Vangelis (29 martie 1943 - 17 mai 2022)
"Cu cât ai mai mult succes, cu atât devii mai mult un produs al ceva care generează bani."



FB
Siteul Muzicantilor

Mobile Theme Setări confidenţialitate

Sitemap