Forums
| Clape.ro :: Forums :: Echipamente si accesorii :: Echipamente audio |
|
<< Previous thread | Next thread >> |
| Mixer yamaha emx5000-12 | ||
| Go to page >> | |
|
Moderators: admin, pustiulica, angelitto
|
| Author | Post | ||
| Kapytanu |
|
||
|
Guest
|
Va salut! Am si eu o intrebare pentru cei care cunosc acest model. Functioneaza la 2 ohmi?
|
||
| Back to top |
|
||
| sarac.lipit |
|
||
  Registered Member #45
Joined: 29 May 2008Posts: 2431 |
teoretic orice amplificator funcţionează de la 2 OHM, doar că ''la blană'' se încinge... da' faci mititei, o ceafă...ceva iar iarna îl ţii la picioare. Pui şi tu cabluri mai lungi şi-i mai măreşti impedanţa. Adevărul este că sună mai prezent cu cît e mai mică impedanţa şi mai fleşcăit spre 16 OHM [ Edited Wed, 02 Apr 2014, 02:20PM ] |
||
| Back to top |
|
||
| Kapytanu |
|
||
|
Guest
|
Ms. Ma interesa daca as putea sa conectez 3 boxe de 8 ohmi pe un canal. Stii ceva sarac lipit? |
||
| Back to top |
|
||
| vermona |
|
||
  Registered Member #307
Joined: 10 Jul 2008Posts: 54 |
nu poti pe modelul emx yamaha
|
||
| Back to top |
|
||
| sarac.lipit |
|
||
|
Registered Member #45
Joined: 29 May 2008Posts: 2431 |
probează şi tu pune 2 înseriate şi una în paralel, dacă-i moale soundu'... pune-le toate-n paralel. Dacă amplifu' are protecţiile OK n-ar trebui să se întîmple nimic... decît să se întrerupă dacă-i prea încins şi-n 2 minute-şi revine |
||
| Back to top |
|
||
| Kapytanu |
|
||
|
Guest
|
am pus. sound-ul nu e moale. nu se schiba cu nimic diferenta la sunet dacapun o boxa pe canal , doua sau trei. se aude volumul la fel nu scade la niciuna. mi-e frica sa nu pateasca ceva nu stiu.
|
||
| Back to top |
|
||
| Kapytanu |
|
||
|
Guest
|
vermona zici ca nu functioneaza in2 ohmi? |
||
| Back to top |
|
||
| ValiS |
|
||
|
Guest
|
Daca in specificatiile mixerului nu spune ca poate fi folosit si in 2 ohmi iti recomand sa nu pui 3 boxe pe canal...Poti arde etajul final,se incinge ca la balamuc..Eu nu as avea incredere.Si eu am un powermate 1000-1 Dynacord,dar n-am curaj sa pun 6 boxe.E alegerea ta..Teoretic ar merge,spune SaracLipit..! Da...dar cred ca doar teoretic...!
|
||
| Back to top |
|
||
| adriankorgpa |
|
||
|
Guest
|
POate ca te ajuta : General specifications Maximum output power SPEAKERS: 500 W+500 W/4W @0.5% THD at 1 kHz 325 W+325 W/8W @0.5% THD at 1 kHz BRIDGE: 1000 W/8W @0.5% THD at 1 kHz Frequency response 20 Hz–20 kHz +1 dB, –3 dB @1 W output into 8W (SPEAKERS OUT) 20 Hz–20 kHz +1 dB, –3 dB @+4 dB output into 600W (ST OUT, ST SUB OUT, MONO OUT, AUX SEND, EFFECT SEND) Total harmonic distortion Less than 0.5% @20 Hz–20 kHz, 250 W output into 4W (SPEAKERS OUT) Less than 0.3% @20 Hz–20 kHz, +14 dB output into 600W (ST OUT, ST SUB OUT, MONO OUT, AUX SEND, EFFECT SEND) Hum & noise (Average, Rs=150W) (with 20 Hz–20 kHz BPF) –128 dB equivalent input noise, –65 dB residual output noise (SPEAKERS OUT) –95 dB residual output noise (ST OUT, ST SUB OUT, AUX SEND) –84 dB (ST OUT, MONO OUT) ST master/MONO master fader at nominal level and all channel On switches off and all channel fader at minimum. –64 dB (68 dB S/N) (ST OUT, MONO OUT) ST master fader at nominal level and one channel On switch on and one channel fader at nominal level and one channel Gain control at nominal level. –81 dB (AUX SEND) Master fader at nominal level and all channel On switches off and all channel level control at minimum. –80 dB (EFFECT SEND) All channel level control at minimum. Maximum voltage gain 108 dB INPUT A/B to SPEAKERS OUT 84 dB INPUT A/B to ST OUT, MONO OUT 80 dB INPUT A/B to AUX SEND (PRE) 90 dB INPUT A/B to AUX SEND (POST) 78 dB INPUT A/B to EFFECT SEND 58 dB ST CH IN to ST OUT Crosstalk at 1 kHz 68 dB adjacent input, 68 dB input to output Input channel equalization ±15 dB Maximum HIGH 10 kHz shelving* MID 250 Hz–5 kHz peaking LOW 100 Hz shelving* * Turn over/roll off frequency of shelving: 3 dB below maximum variable level. ST Input channel equalization ±15 dB Maximum HIGH 10 kHz shelving* MID 2.5 kHz peaking LOW 100 Hz shelving* * Turn over/roll off frequency of shelving: 3 dB below maximum variable level. CH peak indicators Red LED on each channel lits when POST EQ signal reaches the level –3 dB below clipping. CH signal indicators Green LED on each channel lits when POST EQ signal reaches the level –10 dB. Meters 13 points LED meter Power amp select switch 500W + 500W, 300W + 300W, 100W + 100W Limiter Comp. : THD³0.5% (SPEAKERS OUT) LIMIT indicators Turn on : THD³0.5% (SPEAKERS OUT) Graphic equalizer 9 bands (63, 125, 250, 500, 1k, 2k, 4k, 8k, 16k Hz), ±12 dB Maximum Internal digital effect 1 16 programs, parameter control Internal digital effect 2 16 programs, parameter control, tap delay control, foot switch (DIGITAL EFFECT ON/OFF, TAP) Foot switch (FC5) Digital effect 2 mute: on/off, Tap delay Protection circuit (Power amp) POWER switch on/off mute, DC detection, TEMP (heatsink temp. ³90°C) Fan circuit stop — low speed (50°C) — variable — high speed (70°C) Phantom power +48 V (balanced input) Option FC5 (Foot switch), RK-124 (EMX5000-12) Power requirement/ Power consumption USA and Canada:120 V AC 60 Hz, 400 W Europe: 230 V AC 50 Hz, 550 W Other: 240 V AC 50 Hz, 550 W |
||
| Back to top |
|
||
| vermona |
|
||
|
Registered Member #307
Joined: 10 Jul 2008Posts: 54 |
yamaha emx nu are nicio serie care poti pune 3 boxe pe un canal.....lucru clar.......singurul model este dynacord pm 1002....si 1003...dar si alea nu se stie cat functioneaza de bine si mult .....indicat pentru 3 boxe pe canal sunt amplificatoare separate care sunt concepute pentru a fi folosite in regim de forjare...cluburi..concerte...orcum la nunti linistite cu 4 boxe sateliti si doi basi care ar fi bine sa fie activi nu o sa ai treaba...deci nu uita emx nu functioneaza cu 3 boxe pe canal...
|
||
| Back to top |
|
||
| Go to page >> | |
Powered by Clape.ro
Comentarii noi
[download] RoFolclorCM24
Posted by Dima2006 on 09 Jul 2025, 18:39I-am dat de cap. Stiu ca prima data incarci in yem si dupa pe clapa.Dupa ce am sters toate ritmurile din pack s-a incarcat. Am folosit stilurile de pe stick gen in arhiva ai pus si [more ...]
[download] SET StudioRomania 2025, Korg Pa4x - part.1
Posted by ady81 on 09 Jul 2025, 10:16se multumeste pentru gest si set!
[download] RoFolclorCM24
Posted by Mihai13 on 08 Jul 2025, 09:22Dima,Daca nu s-a incarcat in YEM mai descarca-l o data.Daca s-a incarcat in YEM si ai putut face PPI ul si da eroare la incarcare pune PPI pe un alt stick.Daca nu ai stiut PPF nu s [more ...]
[download] Anichei SET Korg PA4x partea 1
Posted by lucianG1000 on 06 Jul 2025, 23:33daca e cel din 2024 nu te mai chinui.... l-am urcat eu de mult timp.
[download] RoFolclorCM24
Posted by Dima2006 on 04 Jul 2025, 23:05Salut Mihai , am incercat sa incarc setul intr-un Tyros 5 , dar imi da ceva erroare (File Task Error) . Ma-ti putea ajuta cumva?
